Presicion Micro Motor (12V 800 RPM w/ Encoder - SURPLUS)

Technical Spesifications
Voltage:	12V	Volt
No Load Current:	19mA (@12V)	MilliAmpere
Stall Current:	325mA (@12V)	MilliAmpere
Gear Ratio:	16:1 (Made in Japan Gearbox)	-
Speed:	800	Revolutions Per Minute
Stall Torque:	224 gcm 22 mNm 3.11 oz-in	Written at left.
Weight:	20.3gr.	Grams
Motor Length:	48.7mm (Without Shaft) 54.00mm (Full Length)	Millimeter
Motor Diameter:	10mm	Millimeter
Shaft Length:	5.3mm D Type	Millimeter
Shaft Diameter:	2mm	Millimeter
Encoder Type	Magnetic, Incremental	-
Encoder Channels	A & B Seperate Outputs	-
Encoder CPR (Counts Per Revolution)	12 CPR (Each Channel)	-
Summed Signal for Combined 1 motor (After gearbox) Shaft Turn	192 CPR (Each Channel, CPR x Gear Ratio)	-
Encoder Voltage	5V	Volt
Cable Definitions	Motor Inputs (2 Wire) Encoder Voltage Input (5V - GND, 2 Wire) Encoder Outputs (A & B Channel)	Total 6 Wire.

What is Encoder Gear Motor?

It is generic micro gear motor with Encoder outputs that you can measure, count motor's speed & position at output.

They are seperate modules from motor that you don't need to use or attach to any board if you don't need. 

Where you can use that motor?

• Micro Robot Projects
• Maze Solver
• Line Follower

And of course you can use it for all projects that suit your own ideas.

Motor Wire Definitions

Motor coming with molex female header that it can be cut. (header picture added to photos) after cutting, you can attach to your system with definition below: (From Left to Right)

• 1st Red Wire: DC Motor Input
• 2nd Grey Wire: Encoder 5V
• 3rd Grey Wire: Encoder A Output
• 4th Grey Wire: Encoder B output
• 5th Grey Wire: Encoder GND
• 6th Grey Wire: Motor Input

You can only attach 1st and 6th wire to test, power your dc motor.

They are very small and special dc gear micromotors. Limited stock available.